4.3.1 AII 2000 A Oxygen Analyzer, AII-2000 M Oxygen Monitor:

1. Remove the contents from the shipping container as shown in section 4.1

and check for damage.

取出一起看有沒有損壞

2. The coiled cable uses a common RJ11 phone jack at both ends, making a

bad connection impossible.

用卷連接線連接

3. Install the sensor away from any humidifying device to prevent moisture

from condensing on the sensing surface and assure accurate calibration

and oxygen readings.

避開潮濕環境來安裝傳感器保證準確讀數

4. Connect one end of the cable to the device in the same manner you

would connect a telephone. Simply find and register the male plug at the

end of the coiled cable and insert it into the mating female jack on the

side of the device.

用連接電話的方式把連接線一頭接到儀器上

5. Connect the other end of the cable to the sensor in the same manner.

連接線另一頭接到傳感器上

6. For diffusion sampling of static, ambient or controlled atmospheres –

incubators, infant hoods, tents, etc., the flow diverter and tee are not

required as shown above.

對于擴散采樣靜態的，環境或受控環境 -
培養箱，嬰兒罩，帳篷等，分流器和發球
需要如上所示。 

7. For sampling breathing circuits with flowing gas, use the flow diverter

and tee adapter accessories supplied with the device, and, position the

sensor vertically for optimum results, as shown right. The flow diverter

avoids stagnation and facilitates the movement of gas to and from the

sensing area of the sensor thereby producing a more accurate measurement

of the gas stream to be measured.

用于采樣電路呼吸氣體流動，使用分流器
T型適配器，配件與設備提供定位
垂直，以獲得*效果的傳感器，如右圖所示。分流器
避免停滯，并有利于氣體的運動和從
從而產生更精確的測量傳感器的感應區
要被測量的氣體流

8. Install the tee-adapter in the breathing circuit.

安裝TEE適配器到呼吸回路

9. Screw the flow diverter to the sensor.

旋轉分流器到傳感器

10. Ensure the o-ring is lightly lubricated for ease of entry and a tight seal

between the flow diverter and tee adapter.

保證分流器適配器之間的O型環密封好

11. Insert the assembled flow diverter/sensor into the tee allowing *

oxygen (dry, non-humidified) to flow past the sensor at a rate less than

10 liters per minute

插入分流器/傳感器到TEE適配器，讓*干氧氣在低于每分鐘10升的量流經傳感器